Register 4 of BLOCK0.
DIS_DOWNLOAD_MODE | Set this bit to disable all download boot modes. |
DIS_LEGACY_SPI_BOOT | Set this bit to disable Legacy SPI boot mode. |
UART_PRINT_CHANNEL | Selects the default UART for printing boot messages. 0: UART0. 1: UART1. |
RPT4_RESERVED3 | Reserved (used for four backups method). |
DIS_USB_DOWNLOAD_MODE | Set this bit to disable use of USB OTG in UART download boot mode. |
ENABLE_SECURITY_DOWNLOAD | Set this bit to enable secure UART download mode (read/write flash only). |
UART_PRINT_CONTROL | Set the default UART boot message output mode. 00: Enabled. 01: Enable when GPIO46 is low at reset. 10: Enable when GPIO46 is high at reset. 11: Disabled. |
PIN_POWER_SELECTION | Set default power supply for GPIO33-GPIO37, set when SPI flash is initialized. 0: VDD3P3_CPU. 1: VDD_SPI. |
FLASH_TYPE | SPI flash type. 0: maximum four data lines, 1: eight data lines. |
FORCE_SEND_RESUME | If set, forces ROM code to send an SPI flash resume command during SPI boot. |
SECURE_VERSION | Secure version (used by ESP-IDF anti-rollback feature). |
RPT4_RESERVED2 | Reserved (used for four backups method). |